Instead of starting an actual installation process, the application will just prompt you to point it to the actual location the library has been stored on.ĥ. Once you've found it, please click on the "Install" button. AFFLATUS should be really easy to spot, at the top of the list. After you are done with this part, please navigate to the "Not Installed" tab of Native Access' interface. Here's a snapshot depicting the confirmation message being displayed upon your success:Ĥ. After you have typed in / pasted these symbols, click on "add serial" again, please. You can get your serial either from the email sent by named "New order on Strezov Sampling", or through the "My Products" section of your user profile on our website. In this article we'll be using AFFLATUS Chapter I Strings as an example. Like the page suggests, please insert the serial number you have for your library. After you log into Native Access successfully, please click on the "Add a serial" button in the upper left corner of the interface:Ģ. Now that all this is out of the way, shall we begin? :)ġ. Last, but not least - you need a functioning Native Instruments user account. You need to have Native Access installed on your workstation. You need to have the library downloaded and extracted as per our installation guides.ĭepending on your operating system of choice, here they are: The following article is here to assist you in navigating this process. If you want to remove the Non-Player Library from the Browser again, click the cogwheel in the bottom left, select the Library and click the Remove button.How to set up a library in Native Access?įirst off - congratulations on your new purchase and a big "Thank you" for trusting our brand.Īs a rule, libraries powered by NI's Kontakt Player need to be activated through Native Access. Click the Library's icon to show its instruments: The Library now appears in KONTAKT's Browser.Click the cogwheel in the bottom left again.Navigate to the Library folder and confirm your selection with OK.Click the disk button in KONTAKT's header and select Batch re-save from the drop-down menu:.It is not recommended to batch re-save an entire disk or directory of Libraries. Batch re-save should only be used on single Libraries.
KONTAKT 7, it will no longer load in KONTAKT 6, KONTAKT 5, etc. In case you need to open the Library with an older KONTAKT version, use this older version of KONTAKT for the Batch re-save process.Important - please read before proceeding: Please use the Batch re-save function to make the Library compatible with KONTAKT 7's Library Browser:
If the Library doesn't appear in the Browser, the Library was made with a KONTAKT version below 5.0.
0 kommentar(er)
